mirror of
https://github.com/esp8266/Arduino.git
synced 2025-04-19 23:22:16 +03:00
1eb0645dcb
* Update requirements.txt * Update conf.py * Update libraries.rst * Update libraries.rst * Update libraries.rst * Update stack_dump.rst * Update client-examples.rst * Update readme.rst * Update readme.rst * Update server-class.rst * Update server-examples.rst * Update soft-access-point-class.rst * Update station-class.rst * Update station-examples.rst * Update udp-class.rst * Update udp-examples.rst * Update a04-board-generic-is-unknown.rst * Update readme.rst * Update readme.rst * Update readme.rst
37 lines
2.2 KiB
ReStructuredText
37 lines
2.2 KiB
ReStructuredText
:orphan:
|
|
|
|
UDP Class
|
|
---------
|
|
|
|
Methods documented for `WiFiUDP Class <https://www.arduino.cc/en/Reference/WiFiUDPConstructor>`__ in `Arduino <https://github.com/arduino/Arduino>`__
|
|
|
|
1. `begin() <https://www.arduino.cc/en/Reference/WiFiUDPBegin>`__
|
|
2. `available() <https://www.arduino.cc/en/Reference/WiFiUDPAvailable>`__
|
|
3. `beginPacket() <https://www.arduino.cc/en/Reference/WiFiUDPBeginPacket>`__
|
|
4. `endPacket() <https://www.arduino.cc/en/Reference/WiFiUDPEndPacket>`__
|
|
5. `write() <https://www.arduino.cc/en/Reference/WiFiUDPWrite>`__
|
|
6. `parsePacket() <https://www.arduino.cc/en/Reference/WiFiUDPParsePacket>`__
|
|
7. `peek() <https://www.arduino.cc/en/Reference/WiFiUDPPeek>`__
|
|
8. `read() <https://www.arduino.cc/en/Reference/WiFiUDPRead>`__
|
|
9. `flush() <https://www.arduino.cc/en/Reference/WiFiUDPFlush>`__
|
|
10. `stop() <https://www.arduino.cc/en/Reference/WiFIUDPStop>`__
|
|
11. `remoteIP() <https://www.arduino.cc/en/Reference/WiFiUDPRemoteIP>`__
|
|
12. `remotePort() <https://www.arduino.cc/en/Reference/WiFiUDPRemotePort>`__
|
|
|
|
Methods and properties described further down are specific to ESP8266.
|
|
They are not covered in `Arduino WiFi library <https://www.arduino.cc/en/Reference/WiFi>`__ documentation. Before they are fully documented please refer to information below.
|
|
|
|
Multicast UDP
|
|
~~~~~~~~~~~~~
|
|
|
|
.. code:: cpp
|
|
|
|
uint8_t beginMulticast (IPAddress interfaceAddr, IPAddress multicast, uint16_t port)
|
|
virtual int beginPacketMulticast (IPAddress multicastAddress, uint16_t port, IPAddress interfaceAddress, int ttl=1)
|
|
IPAddress destinationIP ()
|
|
uint16_t localPort ()
|
|
|
|
The ``WiFiUDP`` class supports sending and receiving multicast packets on STA interface. When sending a multicast packet, replace ``udp.beginPacket(addr, port)`` with ``udp.beginPacketMulticast(addr, port, WiFi.localIP())``. When listening to multicast packets, replace ``udp.begin(port)`` with ``udp.beginMulticast(WiFi.localIP(), multicast_ip_addr, port)``. You can use ``udp.destinationIP()`` to tell whether the packet received was sent to the multicast or unicast address.
|
|
|
|
For code samples please refer to separate section with `examples <udp-examples.rst>`__ dedicated specifically to the UDP Class.
|