prefork Implements a non-threaded, pre-forking web server MPM prefork.c mpm_prefork_module

This Multi-Processing Module (MPM) implements a non-threaded, pre-forking web server that handles requests in a manner similar to Apache 1.3. It is appropriate for sites that need to avoid threading for compatibility with non-thread-safe libraries. It is also the best MPM for isolating each request, so that a problem with a single request will not affect any other.

This MPM is very self-regulating, so it is rarely necessary to adjust its configuration directives. Most important is that MaxClients be big enough to handle as many simultaneous requests as you expect to receive, but small enough to assure that there is enough physical RAM for all processes.

 Setting which addresses and ports Apache uses
How it Works

A single control process is responsible for launching child processes which listen for connections and serve them when they arrive. Apache always tries to maintain several spare or idle server processes, which stand ready to serve incoming requests. In this way, clients do not need to wait for a new child processes to be forked before their requests can be served.

The StartServers, MinSpareServers, MaxSpareServers, and MaxClients regulate how the parent process creates children to serve requests. In general, Apache is very self-regulating, so most sites do not need to adjust these directives from their default values. Sites which need to serve more than 256 simultaneous requests may need to increase MaxClients, while sites with limited memory may need to decrease MaxClients to keep the server from thrashing (swapping memory to disk and back). More information about tuning process creation is provided in the performance hints documentation.

While the parent process is usually started as root under Unix in order to bind to port 80, the child processes are launched by Apache as a less-privileged user. The User and Group directives are used to set the privileges of the Apache child processes. The child processes must be able to read all the content that will be served, but should have as few privileges beyond that as possible.

MaxRequestsPerChild controls how frequently the server recycles processes by killing old ones and launching new ones.

CoreDumpDirectory EnableExceptionHook PidFile Listen ListenBacklog LockFile MaxClients MaxMemFree MaxRequestsPerChild ScoreBoardFile SendBufferSize ServerLimit StartServers User Group AcceptMutex MaxSpareServers Maximum number of idle child server processes MaxSpareServers number MaxSpareServers 10 server config

The MaxSpareServers directive sets the desired maximum number of idle child server processes. An idle process is one which is not handling a request. If there are more than MaxSpareServers idle, then the parent process will kill off the excess processes.

Tuning of this parameter should only be necessary on very busy sites. Setting this parameter to a large number is almost always a bad idea. If you are trying to set the value lower than MinSpareServers, Apache will automatically adjust it to MinSpareServers + 1.

 MinSpareServers StartServers MinSpareServers Minimum number of idle child server processes MinSpareServers number MinSpareServers 5 server config

The MinSpareServers directive sets the desired minimum number of idle child server processes. An idle process is one which is not handling a request. If there are fewer than MinSpareServers idle, then the parent process creates new children at a maximum rate of 1 per second.

Tuning of this parameter should only be necessary on very busy sites. Setting this parameter to a large number is almost always a bad idea.

 MaxSpareServers StartServers