mirror of
https://github.com/MariaDB/server.git
synced 2025-12-24 11:21:21 +03:00
1b99d30c23
Version for 4.0. It fixes two problems: 1. The cause of the bug was that we did not check the table version for the HANDLER ... READ commands. We did not notice when a table was replaced by a new one. This can happen during ALTER TABLE, REPAIR TABLE, and OPTIMIZE TABLE (there might be more cases). I call the fix for this problem "the primary bug fix". 2. mysql_ha_flush() was not always called with a locked LOCK_open. Though the function comment clearly said it must. I changed the code so that the locking is done when required. I call the fix for this problem "the secondary fix".
This directory contains a test suite for mysql daemon. To run the currently existing test cases, simply execute ./mysql-test-run in this directory. It will fire up the newly built mysqld and test it. Note that you do not have to have to do make install, and you could actually have a co-existing MySQL installation - the tests will not conflict with it. All tests must pass. If one or more of them fail on your system, please read the following manual section of how to report the problem: http://dev.mysql.com/doc/mysql/en/MySQL_test_suite.html You can create your own test cases. To create a test case: cd t vi test_case_name.test in the file, put a set of SQL commands that will create some tables, load test data, run some queries to manipulate it. We would appreciate if the test tables were called t1, t2, t3 ... (to not conflict too much with existing tables). Your test should begin by dropping the tables you are going to create and end by dropping them again. This will ensure that one can run the test over and over again. If you are using mysqltest commands (like result file names) in your test case you should do create the result file as follows: mysql-test-run --record test_case_name or mysqltest --record < t/test_case_name.test If you only have a simple test cases consistent of SQL commands and comments you can create the test case one of the following ways: mysql-test-run --record test_case_name mysql test < t/test_case_name.test > r/test_case_name.result mysqltest --record --record-file=r/test_case_name.result < t/test_case_name.test When this is done, take a look at r/test_case_name.result - If the result is wrong, you have found a bug; In this case you should edit the test result to the correct results so that we can verify that the bug is corrected in future releases. To submit your test case, put your .test file and .result file(s) into a tar.gz archive, add a README that explains the problem, ftp the archive to ftp://support.mysql.com/pub/mysql/secret/ and send a mail to bugs@lists.mysql.com