Stabilize test by reseting DEBUG_SYNC and add wait_condition
for expected table contents.
Signed-off-by: Julius Goryavsky <julius.goryavsky@mariadb.com>
Support for galera GTID consistency thru cluster. All nodes in cluster
should have same GTID for replicated events which are originating from cluster.
Cluster originating commands need to contain sequential WSREP GTID seqno
Ignore manual setting of gtid_seq_no=X.
In master-slave scenario where master is non galera node replicated GTID is
replicated and is preserved in all nodes.
To have this - domain_id, server_id and seqnos should be same on all nodes.
Node which bootstraps the cluster, to achieve this, sends domain_id and
server_id to other nodes and this combination is used to write GTID for events
that are replicated inside cluster.
Cluster nodes that are executing non replicated events are going to have different
GTID than replicated ones, difference will be visible in domain part of gtid.
With wsrep_gtid_domain_id you can set domain_id for WSREP cluster.
Functions WSREP_LAST_WRITTEN_GTID, WSREP_LAST_SEEN_GTID and
WSREP_SYNC_WAIT_UPTO_GTID now works with "native" GTID format.
Fixed galera tests to reflect this chances.
Add variable to manually update WSREP GTID seqno in cluster
Add variable to manipulate and change WSREP GTID seqno. Next command
originating from cluster and on same thread will have set seqno and
cluster should change their internal counter to it's value.
Behavior is same as using @@gtid_seq_no for non WSREP transaction.
* MDEV-16509 Improve wsrep commit performance with binlog disabled
Release commit order critical section early after trx_commit_low() if
binlog is not transaction coordinator. In order to avoid two phase commit,
binlog_hton is not registered for THD during IO_CACHE population.
Implemented a test which verifies that the transactions release
commit order early.
This optimization will change behavior during recovery as the commit
is not two phase when binlog is off. Fixed and recorded wsrep-recover-v25
and wsrep-recover to match the behavior.
* MDEV-18730 Ordering for wsrep binlog group commit
Previously out of order execution was allowed for wsrep commits.
Established proper ordering by populating wait_for_commit
for every wsrep THD and making group commit leader to wait for
prior commits before proceeding to trx_group_commit_leader().
* MDEV-18730 Added a test case to verify correct commit ordering
* MDEV-16509, MDEV-18730 Review fixes
Use WSREP_EMULATE_BINLOG() macro to decide if the binlog_hton
should be registered. Whitespace/syntax fixes and cleanups.
* MDEV-16509 Require binlog for galera_var_innodb_disallow_writes test
If the commit to InnoDB is done in one phase, the native InnoDB behavior
is that the transaction is committed in memory before it is persisted to
disk. This means that the innodb_disallow_writes=ON may not prevent
transaction to become visible to other readers before commit is completely
over. On the other hand, if the commit is two phase (as it is with binlog),
the transaction will be blocked in prepare phase.
Fixed the test to use binlog, which enforces two phase commit, which
in turn makes commit to block before the changes become visible to
other connections. This guarantees that the test produces expected
result.
