- FLUSH GLOBAL STATUS now resets most global_status_vars.
At this stage, this is mainly to be used for testing.
- FLUSH SESSION STATUS added as an alias for FLUSH STATUS.
- FLUSH STATUS does not require any privilege (before required RELOAD).
- FLUSH GLOBAL STATUS requires RELOAD privilege.
- All global status reset moved to FLUSH GLOBAL STATUS.
- Replication semisync status variables are now reset by
FLUSH GLOBAL STATUS.
- In test cases, the only changes are:
- Replace FLUSH STATUS with FLUSH GLOBAL STATUS
- Replace FLUSH STATUS with FLUSH STATUS; FLUSH GLOBAL STATUS.
This was only done in a few tests where the test was using SHOW STATUS
for both local and global variables.
- Uptime_since_flush_status is now always provided, independent if
ENABLED_PROFILING is enabled when compiling MariaDB.
- @@global.Uptime_since_flush_status is reset on FLUSH GLOBAL STATUS
and @@session.Uptime_since_flush_status is reset on FLUSH SESSION STATUS.
- When connected, @@session.Uptime_since_flush_status is set to 0.
Compute binlog checksums (when enabled) already when writing events
into the statement or transaction caches, where before it was done
when the caches are copied to the real binlog file. This moves the
checksum computation outside of holding LOCK_log, improving
scalabitily.
At stmt/trx cache write time, the final end_log_pos values are not
known, so with this patch these will be set to 0. Events that are
written directly to the binlog file (not through stmt/trx cache) keep
the correct end_log_pos value. The GTID and COMMIT/XID events at the
start and end of event groups are written directly, so the zero
end_log_pos is only for events in the middle of event groups, which
do not negatively affect replication.
An option --binlog-legacy-event-pos, off by default, is provided to
disable this behavior to provide backwards compatibility with any
external applications that might rely on end_log_pos in events in the
middle of event groups.
Checksums cannot be pre-computed when binlog encryption is enabled, as
encryption relies on correct end_log_pos to provide part of the
nonce/IV.
Checksum pre-computation is also disabled for WSREP/Galera, as it uses
events differently in its write-sets and so on. Extending pre-computation of
checksums to Galera where it makes sense could be added in a future patch.
The current --binlog-checksum configuration is saved in
binlog_cache_data at transaction start and used to pre-compute
checksums in cache, if applicable. When the cache is later copied to
the binlog, a check is made if the saved value still matches the
configured global value; if so, the events are block-copied directly
into the binlog file. If --binlog-checksum was changed during the
transaction, events are re-written to the binlog file one-by-one and
the checksums recomputed/discarded as appropriate.
Reviewed-by: Monty <monty@mariadb.org>
Signed-off-by: Kristian Nielsen <knielsen@knielsen-hq.org>
