1eb0645dcb
* Update requirements.txt * Update conf.py * Update libraries.rst * Update libraries.rst * Update libraries.rst * Update stack_dump.rst * Update client-examples.rst * Update readme.rst * Update readme.rst * Update server-class.rst * Update server-examples.rst * Update soft-access-point-class.rst * Update station-class.rst * Update station-examples.rst * Update udp-class.rst * Update udp-examples.rst * Update a04-board-generic-is-unknown.rst * Update readme.rst * Update readme.rst * Update readme.rst
1.8 KiB
- orphan
Server Class
Methods documented for the Server Class in Arduino
Methods and properties described further down are specific to ESP8266. They are not covered in Arduino WiFi library documentation. Before they are fully documented please refer to information below.
setNoDelay
setNoDelay(nodelay)With nodelay set to true, this function
will to disable Nagle
algorithm.
This algorithm is intended to reduce TCP/IP traffic of small packets sent over the network by combining a number of small outgoing messages, and sending them all at once. The downside of such approach is effectively delaying individual messages until a big enough packet is assembled.
Example:
server.begin();
server.setNoDelay(true);Other Function Calls
bool hasClient ()
bool getNoDelay ()
virtual size_t write (const uint8_t *buf, size_t size)
uint8_t status ()
void close ()
void stop ()Documentation for the above functions is not yet prepared.
For code samples please refer to separate section with examples dedicated specifically to the Server Class.