Moving all AVR specific libraries to hardware/avr

hardware/avr/libraries/Ethernet/examples/TelnetClient/TelnetClient.pde

@@ -0,0 +1,87 @@
+/*
+  Telnet client
+ 
+ This sketch connects to a a telnet server (http://www.google.com)
+ using an Arduino Wiznet Ethernet shield.  You'll need a telnet server 
+ to test this with.
+ Processing's ChatServer example (part of the network library) works well, 
+ running on port 10002. It can be found as part of the examples
+ in the Processing application, available at 
+ http://processing.org/
+ 
+ Circuit:
+ * Ethernet shield attached to pins 10, 11, 12, 13
+ 
+ created 14 Sep 2010
+ by Tom Igoe
+ 
+ */
+
+#include <SPI.h>
+#include <Ethernet.h>
+
+// Enter a MAC address and IP address for your controller below.
+// The IP address will be dependent on your local network:
+byte mac[] = {  
+  0xDE, 0xAD, 0xBE, 0xEF, 0xFE, 0xED };
+IPAddress ip(192,168,1,177);
+
+// Enter the IP address of the server you're connecting to:
+IPAddress server(1,1,1,1); 
+
+// Initialize the Ethernet client library
+// with the IP address and port of the server 
+// that you want to connect to (port 23 is default for telnet;
+// if you're using Processing's ChatServer, use  port 10002):
+Client client;
+
+void setup() {
+  // start the Ethernet connection:
+  Ethernet.begin(mac, ip);
+  // start the serial library:
+  Serial.begin(9600);
+  // give the Ethernet shield a second to initialize:
+  delay(1000);
+  Serial.println("connecting...");
+
+  // if you get a connection, report back via serial:
+  if (client.connect(server, 10002)) {
+    Serial.println("connected");
+  } 
+  else {
+    // if you didn't get a connection to the server:
+    Serial.println("connection failed");
+  }
+}
+
+void loop()
+{
+  // if there are incoming bytes available 
+  // from the server, read them and print them:
+  if (client.available()) {
+    char c = client.read();
+    Serial.print(c);
+  }
+
+  // as long as there are bytes in the serial queue,
+  // read them and send them out the socket if it's open:
+  while (Serial.available() > 0) {
+    char inChar = Serial.read();
+    if (client.connected()) {
+      client.print(inChar); 
+    }
+  }
+
+  // if the server's disconnected, stop the client:
+  if (!client.connected()) {
+    Serial.println();
+    Serial.println("disconnecting.");
+    client.stop();
+    // do nothing:
+    while(true);
+  }
+}
+
+
+
+