Deleting ole examples in progress

WiFi/examples/WifiChatServer/WifiChatServer.ino

@@ -1,99 +0,0 @@
-/*
- Wifi Chat  Server
- 
- A simple server that distributes any incoming messages to all
- connected clients.  To use telnet to  your device's IP address and type.
- You can see the client's input in the serial monitor as well.
-  
-  This example obtains an IP address from the Wifi router and
-  reports it.
- 
-  Circuit:
- * WiFi shield attached
- 
- created 21 May 2011
- by Tom Igoe
- 
- */
-
-#include <SPI.h>
-#include <WiFi.h>
-#include <IPAddress.h>
-
-char ssid[] = "yourWifiNetwork";
-char pass[] = "seekrit-password";
-int status = WL_IDLE_STATUS;
-// telnet defaults to port 23
-Server server(23);
-boolean gotAMessage = false; // whether or not you got a message from the client yet
-
-void setup() {
-  Serial.begin(9600);
-  Serial.println("Attempting to connect to WPA network...");
-  Serial.print("SSID: ");
-  Serial.println(ssid);
-
-  status = WiFi.begin(ssid, pass);
-  if ( status == WL_CONNECTED) {
-    // start listening for clients
-    server.begin();
-     Serial.println("Wifi shield is idle");
-    // report the IP address:
-    IPAddress myIPAddress = WiFi.localIp();
-    Serial.print("My IP Address: ");
-    Serial.print(WiFi.localIp()[3]);
-    Serial.print(".");
-    Serial.print(WiFi.localIp()[2]);
-    Serial.print(".");
-    Serial.print(WiFi.localIp()[1]);
-    Serial.print(".");
-    Serial.println(WiFi.localIp()[0]); 
-  } else {
-    // if you didn't get a wifi connection, report what happened:
-   switch (status) {
-      case WL_IDLE_STATUS:
-      Serial.println("Wifi connection succeeded");
-      break;
-      case WL_NO_SSID_AVAIL:
-       Serial.println("No Wifi network available");
-        break;
-      case WL_CONNECT_FAILED:
-       Serial.println("Wifi connection failed");
-        break;
-      case WL_CONNECTION_LOST:
-       Serial.println("Wifi connection lost");
-        break;
-      case WL_DISCONNECTED:
-       Serial.println("Wifi disconnected");
-     break;
-   }
-  }
-}
-
-void loop() {
-  // wait for a new client:
-  Client client = server.available();
-
-  // when the client sends the first byte, say hello:
-  if (client) {
-    if (!gotAMessage) {
-      Serial.println("I have a new client");
-      client.println("Hello, client!"); 
-      gotAMessage = true;
-    }
-
-    // read the bytes incoming from the client:
-    char thisChar = client.read();
-    // echo the bytes back to the client:
-    server.write(thisChar);
-    // echo the bytes to the server as well:
-    Serial.print(thisChar);
-  }
-}
-
-
-
-
-
-
-