Run new astyle formatter against all the examples

libraries/EEPROM/examples/eeprom_clear/eeprom_clear.ino

@@ -13,7 +13,7 @@ void setup()
   // write a 0 to all 512 bytes of the EEPROM
   for (int i = 0; i < 512; i++)
     EEPROM.write(i, 0);
-    
+
   // turn the LED on when we're done
   digitalWrite(13, HIGH);
 }

libraries/EEPROM/examples/eeprom_read/eeprom_read.ino

@@ -1,7 +1,7 @@
 /*
  * EEPROM Read
  *
- * Reads the value of each byte of the EEPROM and prints it 
+ * Reads the value of each byte of the EEPROM and prints it
  * to the computer.
  * This example code is in the public domain.
  */
@@ -25,19 +25,19 @@ void loop()
 {
   // read a byte from the current address of the EEPROM
   value = EEPROM.read(address);
-  
+
   Serial.print(address);
   Serial.print("\t");
   Serial.print(value, DEC);
   Serial.println();
-  
+
   // advance to the next address of the EEPROM
   address = address + 1;
-  
+
   // there are only 512 bytes of EEPROM, from 0 to 511, so if we're
   // on address 512, wrap around to address 0
   if (address == 512)
     address = 0;
-    
+
   delay(500);
 }

libraries/EEPROM/examples/eeprom_write/eeprom_write.ino

@@ -22,17 +22,17 @@ void loop()
   // 0 to 1023 and each byte of the EEPROM can only hold a
   // value from 0 to 255.
   int val = analogRead(0) / 4;
-  
+
   // write the value to the appropriate byte of the EEPROM.
   // these values will remain there when the board is
   // turned off.
   EEPROM.write(addr, val);
-  
-  // advance to the next address.  there are 512 bytes in 
+
+  // advance to the next address.  there are 512 bytes in
   // the EEPROM, so go back to 0 when we hit 512.
   addr = addr + 1;
   if (addr == 512)
     addr = 0;
-  
+
   delay(100);
 }