Updating examples.

build/shared/dist/examples/Digital/Blink/Blink.pde

@@ -0,0 +1,25 @@
+/*
+ * Blink
+ *
+ * The basic Arduino example.  Turns on an LED on for one second,
+ * then off for one second, and so on...  We use pin 13 because,
+ * depending on your Arduino board, it has either a built-in LED
+ * or a built-in resistor so that you need only an LED.
+ *
+ * http://www.arduino.cc/en/Tutorial/Blink
+ */
+
+int ledPin = 13;                // LED connected to digital pin 13
+
+void setup()                    // run once, when the sketch starts
+{
+  pinMode(ledPin, OUTPUT);      // sets the digital pin as output
+}
+
+void loop()                     // run over and over again
+{
+  digitalWrite(ledPin, HIGH);   // sets the LED on
+  delay(1000);                  // waits for a second
+  digitalWrite(ledPin, LOW);    // sets the LED off
+  delay(1000);                  // waits for a second
+}