Initial Arduino IDE based on Processing.

build/macosx/dist/lib/Makefile

@@ -0,0 +1,38 @@
+# Arduino Makefile (for Mac OS X)
+# Nick Zambetti and David A. Mellis
+# $Id: makefile.osx,v 1.6 2005/05/23 17:19:56 mellis Exp $
+
+# By default, this makefile uses the serial device specified by
+# Wiring (either in the Tools | Serial Port menu or the Wiring
+# preferences file in the sketchbook directory) and passed as
+# an argument to make.  To override this value, uncomment the
+# following line and change the value to the desired device.
+# SERIAL=/dev/tty.usbserial-1B1
+
+# The Wiring Lite IDE runs the "compile" rule when you click the play button.
+compile:
+	rm -rf tmp
+	mkdir tmp
+	cat ../core/wiringlite.inc > tmp/prog.c
+	cat build/*.c >> tmp/prog.c
+	cp ../core/* tmp/
+	../tools/gnumake -s -C tmp
+
+# The IDE runs the "program" rule when you hit the export button.
+# The string after the colon determines the method used to 
+# program the microcontroller: program-using-bootloader or
+# program-with-isp.
+program: program-using-bootloader
+
+# This rule is for uploading code using a bootloader already on
+# the microcontroller.  It should run at the baud rate specified
+# in the bootloader's code, current 9600 baud.
+program-using-bootloader:
+	../../tools/avr/bin/uisp -dprog=stk500 -dspeed=9600 -dserial=${SERIAL} -dpart=ATmega8 if=tmp/prog.hex --upload
+
+# This rule is for uploading code using an in-system programmer,
+# e.g. the one sold by Atmel.  In this case, you want to erase the
+# microcontroller, upload the code, and then verify it.
+# Atmel's isp follows the stk500 protocol and works at 115200 baud.
+program-with-isp:
+	../../tools/avr/bin/uisp -dprog=stk500 -dspeed=115200 -dserial=${SERIAL} -dpart=ATmega8 if=tmp/prog.hex --erase --upload --verify