Bridge library to the 1.5 format

libraries/Bridge/examples/ShellCommands/ShellCommands.ino

@@ -0,0 +1,53 @@
+/*
+  Running shell commands using Process class. 
+ 
+ This sketch demonstrate how to run linux shell commands
+ using an Arduino Yún. It runs the wifiCheck script on the linino side
+ of the Yun, then uses grep to get just the signal strength line.
+ Then it uses parseInt() to read the wifi signal strength as an integer,
+ and finally uses that number to fade an LED using analogWrite().
+ 
+ The circuit:
+ * Arduino Yun with LED connected to pin 9
+ 
+ created 12 Jun 2013
+ by Cristian Maglie
+ modified 25 June 2013
+ by Tom Igoe
+ 
+ This example code is in the public domain.
+ 
+ */
+
+#include <Process.h>
+
+void setup() {
+  Bridge.begin();	// Initialize the Bridge
+  Serial.begin(9600);	// Initialize the Serial
+
+  // Wait until a Serial Monitor is connected.
+  while(!Serial);
+}
+
+void loop() {
+  Process p;
+  // This command line runs the WifiStatus script, (/usr/bin/pretty-wifi-info.lua), then 
+  // sends the result to the grep command to look for a line containing the word
+  // "Signal:"  the result is passed to this sketch:
+  p.runShellCommand("/usr/bin/pretty-wifi-info.lua | grep Signal");
+
+  // do nothing until the process finishes, so you get the whole output:
+  while(p.running());  
+
+  // Read command output. runShellCommand() should have passed "Signal: xx&":
+  while (p.available()) {
+    int result = p.parseInt();			// look for an integer
+    int signal = map(result, 0, 100, 0, 255);	// map result from 0-100 range to 0-255
+    analogWrite(9, signal);			// set the brightness of LED on pin 9
+    Serial.println(result);			// print the number as well
+  } 
+  delay(5000);  // wait 5 seconds before you do it again
+}
+
+
+