Committing individual examples instead of one .zip

build/shared/dist/examples/digital IO/digital_read/digital_read.pde

@@ -0,0 +1,31 @@
+/* Basic Digital Read
+ * ------------------ 
+ *
+ * turns on and off a light emitting diode(LED) connected to digital  
+ * pin 13, when pressing a pushbutton attached to pin 7. It illustrates the
+ * concept of Active-Low, which consists in connecting buttons using a
+ * 1K to 10K pull-up resistor.
+ *
+ * Created 1 December 2005
+ * copyleft 2005 DojoDave <http://www.0j0.org>
+ * http://arduino.berlios.de
+ *
+ */
+ 
+int ledPin = 13; // choose the pin for the LED
+int inPin = 7;   // choose the input pin (for a pushbutton)
+int val = 0;     // variable for reading the pin status
+
+void setup() {
+  pinMode(ledPin, OUTPUT);  // declare LED as output
+  pinMode(inPin, INPUT);    // declare pushbutton as input
+}
+
+void loop(){
+  val = digitalRead(inPin);  // read input value
+  if (val == HIGH) {         // check if the input is HIGH (button released)
+    digitalWrite(ledPin, LOW);  // turn LED OFF
+  } else {
+    digitalWrite(ledPin, HIGH);  // turn LED ON
+  }
+}

build/shared/dist/examples/digital IO/digital_read_and_blink/digital_read_and_blink.pde

@@ -0,0 +1,24 @@
+/* Blink when Digital Read
+ * ------------------------ 
+ */
+ 
+int ledPin = 13; // choose the pin for the LED
+int inPin = 7;   // choose the input pin (for a pushbutton)
+int val = 0;     // variable for reading the pin status
+
+void setup() {
+  pinMode(ledPin, OUTPUT);  // declare LED as output
+  pinMode(inPin, INPUT);    // declare pushbutton as input
+}
+
+void loop(){
+  val = digitalRead(inPin);  // read input value
+  if (val == HIGH) {         // check if the input is HIGH (button released)
+    digitalWrite(ledPin, LOW);  // turn LED OFF
+  } else {
+    digitalWrite(ledPin, HIGH);  // blink the LED and go OFF
+    delay(200);
+    digitalWrite(ledPin, LOW);
+    delay(1000);
+  }
+}